HEIDENHAIN SW 548328-05 DIN Programming - Manual (Page 269)

HEIDENHAIN MANUALplus 620, CNC PILOT 620/640
269
4.1
7
Cont
our
-based t
u
rn
ing cy
cles
Cycle run
1
Calculates the areas to be machined and the cutting
segmentation.
2 Approaches workpiece for first pass from starting point, taking
the safety clearance into account (first in X direction, then in Z).
3
Move at feed rate to target point X
4
Depending on H:
 H=0: Machines the contour outline
 H=1 or 2: Retracts at 45°
5
Returns at rapid traverse and approaches for next pass.
6
Repeats 3 to 5 until target point Z has been reached.
7 If required, repeats 2 to 6 until all areas have been machined.
8 If H=1: Smoothes the contour
9
Retracts as programmed in Q.