HEIDENHAIN SW 548328-05 DIN Programming - Manual (Page 230)

230
DIN programming
4.7 F
ront and r
ear f
a
ce cont
ours
Linear pattern on front/rear face G401-Geo
G401 defines a linear hole pattern or figure pattern on the front or rear
face. G401 is effective for the hole/figure defined in the following
block (G300 to 305, G307).
Parameters
Q Number of figures (default: 1)
XK Starting point in Cartesian coordinates
YK Starting point in Cartesian coordinates
I
End point in Cartesian coordinates
J End point in Cartesian coordinates
Ii Distance (XKi) between figures (pattern distance)
Ji Distance (YKi) between figures (pattern distance)
A Angle of longitudinal axis to XK axis (default: 0°)
R Total length of pattern
Ri Distance between figures (pattern distance)
 Program the hole/figure in the following block without a
center.
 The milling cycle (MACHINING section) calls the hole/
figure in the following block—not the pattern definition.