HEIDENHAIN SW 548328-05 DIN Programming - Manual (Page 314)

314
DIN programming
4.22 Dr
illing cy
cles
4.22 Drilling cycles
Overview of drilling and boring cycles and
contour reference
The drilling and boring cycles can be used with driven or stationary
tools.
Drilling and boring cycles:
 G71 Simple drilling: Page 315
 G72 Boring/countersinking (only with contour reference (ID,
NS): Page 317
 G73 Tapping (not with G743–G746): Page 324
 G74 Deep-hole drilling: Page 321
 G36 Tapping—single path (direct position input): Page 320
 G799 Thread milling (direct position input): Page 328
Pattern definitions:
 G743 Linear pattern on face for drilling and milling cycles: Page 324
 G744 Linear pattern on lateral surface for drilling and milling
cycles: Page 326
 G745 Circular pattern on face for drilling and milling
cycles: Page 325
 G746 Circular pattern on lateral surface for drilling and milling
cycles: Page 327
Possibilities of defining a contour reference:
 Path definition directly in the cycle.
 Reference to a hole or pattern definition in the contour section (ID,
NS) for machining on the front face or lateral surface.
 Centric hole in the turning contour (G49): Page 212
 Pattern definition in the block before the cycle call (G743 - G746)