HEIDENHAIN SW 548328-05 DIN Programming - Manual (Page 336)

336
DIN programming
4.25 Lat
er
al surf
ace mac
h
ining
Line segment on lateral surface G111
G111 moves the tool on a linear path at the feed rate to the "end point."
Example: G111
. . .
[G111, G120]
N1 T8 G197 S1200 G195 F0.2 M104
N2 M14
N3 G120 X100
N4 G110 C0
N5 G0 X110 Z5
N6 G41 Q2 H0
N7 G110 Z-20 CY0
N8 G111 Z-40 [linear path on lateral surface]
N9 G113 CY39.2699 K-40 J19.635
N10 G111 Z-20
N11 G113 CY0 K-20 J19.635
N12 G40
N13 G110 X105
N14 M15
. . .
Parameters
Z End point
C End angle—for angle direction, see graphic support window
CY End point as linear value (referenced to unrolled reference
diameter G120)
X End point (diameter value) – (default: current X position)
Parameters for contour description (G80)
AN Angle to positive Z axis
BR Chamfer/rounding. Defines the transition to the next contour
element. When entering a chamfer/rounding, program the
theoretical end point.
 No entry: Tangential transition
 BR=0: No tangential transition
 BR>0: Rounding radius
 BR<0: Width of chamfer
Q Point of intersection. End point if the line segment intersects a
circular arc (default: 0):
 Q=0: Near point of intersection
 Q=1: Far point of intersection
Using the parameters AN, BR and Q is only allowed if the
contour description is concluded by G80 and used for a
cycle.
Programming:
 Z, C, CY:
Absolute, incremental, or modal
 Program either Z–C or Z–CY