HEIDENHAIN SW 548328-05 DIN Programming - Manual (Page 44)

44
NC programming
1
.2 The smar
t.T
u
rn
edit
or
"Graphics" pull-down menu
The "Graph." pull-down menu contains the following functions (see
figure at right):
 Graphic On
: Activates the graphic window or updates the displayed
contour. As an alternative, you can use the soft key (see table at
right).
 Graphic Off
: Closes the graphic window.
 Graphic for Automatic
: The graphic window is activated when the
cursor is located in the contour description.
 Window : Sets the graphic window. During editing, the Control
displays programmed contours in up to four graphic windows. Set
the desired windows.
 Magnifier on : Activates the zoom function. As an alternative, you
can use the soft key (see table at right).
The graphic window:
 Colors in contour graphics:
 White: workpiece blank and auxiliary blank
 Yellow: finished part
 Blue: auxiliary contours
 Red: contour element at the current cursor position. The arrow
point indicates the direction of machining.
 When programming fixed cycles, you can use the displayed contour
for establishing block references.
 Using the zoom functions, you can magnify, reduce or shift details.
Soft keys with active program window
Activates the contour display and
starts redrawing the contour.
Opens the soft-key menu for the
zoom functions and displays the zoom
frame.
 Additions/changes to the contour will not be considered
until the GRAPHICS soft key is pressed again.
 Unambiguous NC block numbers are a prerequisite for
the contour display!