HEIDENHAIN SW 548328-05 DIN Programming - Manual (Page 338)

338
DIN programming
4.26 Milling cy
cles
4.26 Milling cycles
Overview of milling cycles
 G791 Linear slot on the face. The position and length of the slot are
defined directly in the cycle; slot width = cutter diameter: Page 339
 G792 Linear slot on the lateral surface. The position and length of
the slot are defined directly in the cycle; slot width = cutter
diameter: Page 340
 G793 Contour and figure milling cycle on the face. The contour is
described directly after the cycle and concluded by G80
(compatibility cycle MANUALplus 4110): Page 341
 G794 Contour and figure milling cycle on the lateral surface. The
contour is described directly after the cycle and concluded by G80
(compatibility cycle MANUALplus 4110): Page 343
 G797 Face milling. Mills figures (circles, polygons, individual
surfaces, contours) as islands on the face: Page 345
 G798 Helical slot milling. Mills a helical slot on the lateral surface,
slot width = cutter diameter: Page 347
 G840 Contour milling. Mills ICP contours and figures. Closed
contours are machined inside/outside of the contour, or on the
contour. Open contours are machined from the left/right of the
contour, or on the contour. G840 is used on the face and lateral
surface: Page 348
 G845 Pocket milling—roughing. Roughs out closed ICP contours
and figures on the face and lateral surface: Page 358
 G846 Pocket milling—finishing. Finishes closed ICP contours and
figures on the face and lateral surface: Page 364
Contour definitions in the MACHINING section (figures)
 Face
 G301 Linear slot: Page 227
 G302/G303 Circular slot: Page 227
 G304 Full circle: Page 228
 G305 Rectangle: Page 228
 G307 Eccentric polygon: Page 229
 Lateral surface
 G311 Linear slot: Page 236
 G312/G313 Circular slot: Page 236
 G314 Full circle: Page 237
 G315 Rectangle: Page 237
 G317 Eccentric polygon: Page 238