HEIDENHAIN SW 548328-05 DIN Programming - Manual (Page 220)

220
DIN programming
4.6 C-axis cont
ours—F
undamentals
Circular pattern with circular slots
For circular slots in circular patterns you program the pattern positions,
the center of curvature, the curvature radius and the position of the
slots.
The Control positions the slots as follows:
 Slots are arranged at the distance of the pattern radius about the
pattern center
if
 Pattern center = center of curvature and
 Pattern radius = curvature radius
 Slots are arranged at the distance of the pattern radius + curvature
radius
about the pattern center if
 Pattern center <> center of curvature or
 Pattern radius <> curvature radius
In addition, the position influences the arrangement of the slots:
 Normal position: The starting angle of the slot applies as a relative
value to the pattern position. The starting angle is added to the
pattern position.
 Original position: The starting angle of the slot applies as an
absolute value to the pattern position.
The following examples show the programming of a circular pattern
with circular slots: