HEIDENHAIN SW 548328-05 DIN Programming - Manual (Page 155)

HEIDENHAIN MANUALplus 620, CNC PILOT 620/640
155
2.1
1
Units—Special oper
ations
"Defaults" form
GWW
Tool change point
 No axis (do not approach the tool change point)
 0: Simultaneous (X and Z axes depart diagonally)
 1: First X, then Z
 2: First Z, then X
 3: Only X
 4: Only Z
 5: Only Y
 6: Simultaneous with Y
CLT Coolant
 0: Without
 1: Circuit 1 on
 2: Circuit 2 on
G60 Protection zone: (default for drilling units)
 0: Active
 1: Inactive
"Global" form
G47
Safety clearance
SCK Safety clearance in infeed direction (drilling and milling)
SCI Safety clearance in the working plane (milling)
I, K Oversize in X, Z direction (X: diameter value)
You can load the zero point shift and the tool change point
by soft key (see soft-key table).
 The setting in the "TC point" form applies only within the
current program.
 Position of tool change point (WX1, WZ1, WY1):
 If the tool change point is defined, you use G14 to
move to this position.
 If the tool change point is not defined, you use G14 to
move to the position defined in manual mode.