HEIDENHAIN SW 548328-05 DIN Programming - Manual (Page 574)

574
Overview of units
9.6 Units—"Milling in Y axis" gr
oup
9.6 Units—"Milling in Y axis" group
"Milling in front face" group (XY plane)
Unit Description Page
G840_Kon_Y_Stirn G840 Contour milling
Machining contours in the XY plane inside, outside and on the contour
Page 169
G845_Tas_Y_Stirn G845 Pocket milling
Inside rough-out of closed contours in the XY plane
Page 170
G840_ENT_Y_STIRN G840 Deburring
Deburring contours in the XY plane
Page 174
G801_GRA_STIRN_C G841 Single surface
Milling a single surface (flat) in the XY plane
Page 171
G840_Kon_C_STIRN
G843 Centric polygon
Milling a centric polygon in the XY plane
Page 172
G803_GRA_Y_STIRN
G803 Engraving
Engraving character strings in the XY plane
Page 173
G800_GEW_Y_STIRN
G800 Thread milling
Milling a thread in an existing hole in the XY plane
Page 175