HEIDENHAIN SW 548328-05 DIN Programming - Manual (Page 450)

450
Touch probe cycles
5.4 Calibr
a
ting t
ouc
h pr
obes
Q Tool orientation: Orient the touch probe in the programmed
probing direction before each probing operation (machine-
dependent function)
P PRINT outputs
 0: OFF: Do not show measuring results
 1: ON: Display measuring results
H INPUT instead of measurement
 0: Default: Obtain measured values by probing
 1: PC test: Simulate probing cycle on the programming station
AN Log no.: Save measurement results in
"TNC:\table\messpro.mep" table (line numbers 0–99; the table
can be expanded if necessary)
Parameters