HEIDENHAIN SW 548328-05 DIN Programming - Manual (Page 513)

HEIDENHAIN MANUALplus 620, CNC PILOT 620/640
513
6.7 Milling cy
cles f
o
r the Y axis
Cycle run
1
Starting position (X, Y, Z, C) is the position before the cycle
begins.
2
Calculates the number of cuts (infeeds to the milling planes,
infeeds in the milling depths) and the plunging positions and
paths for reciprocating or helical plunges.
3 Approaches to safety clearance and, depending on O, feeds to
the first milling depth or approaches helically or on a
reciprocating path.
4 Mills a plane.
5 Retracts by the safety clearance, returns and cuts to the next
milling depth.
6 Repeat steps 4 and 5 until the complete surface is milled.
7 Returns to retraction plane RB.