HEIDENHAIN SW 548328-05 DIN Programming - Manual (Page 140)

140
smart.Turn units
2.9 Units—Milling, f
a
ce
"Engraving, face" unit
The unit engraves character strings in linear or polar layout on the face
of the workpiece. Diacritics and special characters that you cannot
enter in the smart.Turn editor can be defined, character by character,
in NF. If you program "Continue from last text" (Q=1), tool change and
pre-positioning are suppressed. The technological data of the previous
engraving cycle apply.
Unit name: G801_GRA_STIRN_C / Cycle: G801 (see page 368)
Character set: see page 366
Access to the technology database:
 Machining operation: Engraving
 Affected parameters: F, S
Position form
X, C
Polar starting point
XK, YK Cartesian starting point
Z End point. Z position, infeed depth during milling.
RB Return plane
Cycle form
TXT
Text to be engraved
NF Character number (character to be engraved)
H Font height
E Distance factor (for calculation see figure)
W Inclination angle
FZ Plunging feed rate factor (plunging feed rate = current feed
rate * FZ)
V Execution
 0: Linear
 1: Arched above
 2: Arched below
D Reference diameter
Q Continue from last text
 0 (No): Engraving starts at the starting point
 1 (Yes): Engraving starts at the tool position
Further forms: see page 58