Adept AdeptSight User Guide - Manual (Page 94)

AdeptSight Camera Calibration Wizard - Automated, no Belt
Edit Window
l
Locating the Target
See the figure Located Calibration Target.
1. Adjust the bounding box to the work area. This must include the calibration tar-
get.
This will most likely be correctly adjusted from the calibration procedure.
2. If no magenta origin marker is displayed, click Run.
If necessary, move the target so it can be located, then click Run.
3. Click Next. The robot should move to the target.
l Continue testing the calibration
o I wish to continue testing
l
Move the robot to the location where the picture is taken
l
Locating the calibration target
o Do not continue testing
AdeptSight User's Guide, Version 3.2.x, Updated: 8/23/2012
Page 94