Adept AdeptSight User Guide - Manual (Page 351)

Edge Pair Collection Editor
The caliper tool can measure any number of pairs. When the caliper is executed, it first
applies edge detection parameters to the entire region of interest. Then, the tool applies pair
settings constraints to determine which edges are valid. Results are then calculated for each
valid edge pair as well as for individual edges in each edge pair.
Pairs Configuration List
The Pairs list of the Edge Pair Collection Editor contains a list of all the pair configurations for
the current caliper tool. This list always contains at least one pair configuration, which is
named Pair 0 by default.
Each pair configuration has a name, with polarity and constraints for the first edge and sec-
ond edge.
From the Edge Pair Collection Editor, you can:
l Access the parameters for each pair configuration
l
Add and remove edge pair configurations
l
Rename edge pair configurations
Configuring Caliper Properties
AdeptSight User's Guide, Version 3.2.x, Updated: 8/23/2012
Page 351