Adept AdeptSight User Guide - Manual (Page 105)

l
Drag the origin marker to the center of the model with the mouse
or
l Click Edit
o Click Center to center the marker on the bounding box
or
o Click on the outline of the model, then click Center to center the
marker on the found part
The Edit window is shown in the following figure.
Edit Window
l Locate the Target
See the following figure.
AdeptSight Camera Calibration Wizard - Automated, with Belt
AdeptSight User's Guide, Version 3.2.x, Updated: 8/23/2012
Page 105