Adept AdeptSight User Guide User Manual
Page 150
AdeptSight Camera Calibration Wizard - Manual with Belt
Edit Window
l
Locating the Target
1. Close the Pendant window, if open (click Cancel).
2. Click Run.
The target should be marked with a magenta origin marker. If not, move the
target, and click Run again.
l
Advance the Belt
The robot should go to the target when you click Next.
l
Continue testing the calibration
o
I wish to continue testing
l
Move the robot to the location where the picture is taken
l
Locating the calibration target
l
Advance the belt
AdeptSight User's Guide, Version 3.2.x, Updated: 8/23/2012
Page 150