Adept AdeptSight User Guide User Manual
Page 139
Edit Window
l
Locate the Target
1. Adjust the bounding box to the work area. This must include the calibration tar-
get.
NOTE: The calibration target should be correctly adjusted from the cal-
ibration procedure.
2. If no magenta origin marker is displayed, click Run.
If necessary, move the target so it can be located, then click Run.
3. Click Next. The robot should move to the target.
l
Continue testing the calibration
o
I wish to continue testing
l
Move the robot to the location where the picture is taken
l
Locating the calibration target
AdeptSight Camera Calibration Wizard - Manual, no Belt
AdeptSight User's Guide, Version 3.2.x, Updated: 8/23/2012
Page 139