Adept AdeptSight User Guide - Manual (Page 491)

Portions of the contour that are not within the Conformity Tolerance range are not con-
sidered to be valid. Only the contours within Conformity Tolerance are recognized and cal-
culated for the Minimum Model Recognition search constraint.
Tolerance is either Default or user-specified.
Conformity Tolerance
NOTE: To manually set a Conformity Tolerance value, you must first uncheck the Use
Default box.
Use Default
The default value is computed by the Locator tool by analyzing the calibration,
the contour detection parameters, and the search parameters.
If the Use Default box is checked, the default value will be used.
Search
AdeptSight User's Guide, Version 3.2.x, Updated: 8/23/2012
Page 491