Adept AdeptSight User Guide - Manual (Page 70)

Testing the Calibration
4. Advance the belt.
The robot should track the part on the belt.
Testing the Calibration
The test procedure repeats the test performed at the end of the belt calibration wizard.
Testing the Calibration
1. Close the Pendant window, if it is open (click Cancel).
2. Click Start Tracking.
3. Place a part under the robot.
4. Advance the belt.
The robot should track the part.
Related Topics
Calibrations on page 51
AdeptSight Belt Calibration on page 55
AdeptSight Belt Calibration Interview Wizard on page 59
AdeptSight Camera Calibration Interview Wizard on page 75
AdeptSight Camera Calibration Wizard - Automated, no Belt on page 85
AdeptSight Camera Calibration Wizard - Automated, with Belt on page 97
AdeptSight Camera Calibration Wizard - Automated, Arm-Mount on page 109
AdeptSight Camera Calibration Wizard - Automated Upward-Looking on page 121
AdeptSight User's Guide, Version 3.2.x, Updated: 8/23/2012
Page 70