Adept AdeptSight User Guide - Manual (Page 118)

AdeptSight Camera Calibration Wizard - Automated, Arm-Mount
Edit Window
l
Locate the Target
1. Adjust the bounding box to the work area. This must include the calibration tar-
get.
NOTE: The calibration target should be correctly adjusted from the cal-
ibration procedure.
2. If no magenta origin marker is displayed, click Run.
If necessary, move the target so it can be located, then click Run.
3. Click Next. The robot should move to the target.
l Continue testing the calibration
o I wish to continue testing
l
Move the robot to the location where the picture is taken
l
Locating the calibration target
o Do not continue testing
AdeptSight User's Guide, Version 3.2.x, Updated: 8/23/2012
Page 118