Adept AdeptSight User Guide - Manual (Page 114)

AdeptSight Camera Calibration Wizard - Automated, Arm-Mount
l
Take a Picture of the Calibration Target
Located Calibration Target
1. Adjust the bounding box to the work area. This must include the calibration tar-
get, as shown in the previous figure.
2. If no magenta origin marker is displayed, click Run.
If necessary, move the target so it can be located, then click Run.
3. Click Next.
l
Define Calibration Point
1. Move the robot to the target.
Click Pendant to display the Pendant window. This enables you to move the
robot, so that the end-effector is centered over the target.
2. Click Here.
AdeptSight User's Guide, Version 3.2.x, Updated: 8/23/2012
Page 114