CommScope ATC300-2000 - Manual (Page 99)

ATC300-1000/2000 Teletilt ® RET System Section 9–Uploading Controller Firmware Using the IP Config Tool
Bulletin 639544 • Revision L August 2014 9-11
Figure 9-11. FTP Server Not Connected.
1. Status indicates
the FTP server
is not connect-
ed.
2. Click on OK.
3. Click on
Close.
9.7 Uploading Controller Firmware from the ATC300 Web Interface
As of ATC300 version 2.34_A, the controller no longer requires IP Config Tool or a third-party FTP
server to upload controller firmware or antenna definition files. To upload a system file, navigate to
Configuration → Software Config, select “Install System File”, find and select the controller firmware
file or antenna definition file (Andrew or non-Andrew), and then click on “Open”.
After a controller firmware file has been uploaded, the ATC300 must be rebooted to complete the
installation.