beautypg.com

4 changing tma gain – CommScope ATC300-2000 User Manual

Page 183

background image

Section 23–Tower Mounted Amplifier

ATC300-1000/2000 Teletilt

®

RET System

23-4

August 2014

Bulletin 639544 • Revision L

23.4 Changing TMA Gain

To change a TMA’s gain, select the TMA from the TMA device information list on the control-

1.

ler’s main screen, as shown in Figure 23-6. Then click on Change TMA Gain to enter the TMA
Device Operation screen (Figure 23-7). Notice that the ID for the device that was selected from
the main screen appears in the title bar of the Device Operation screen.

Required fields are marked with an asterisk. Saving a new configuration will not be permitted if

2.

any of the required fields are left blank. Refer to Figure 23-5.

3. Specify the parameters for the fields available (Base Station ID, Sector, Installer ID and Installa

tion date).

Note the following:

The

ID for the base station associated with this antenna must be 1 to 12 characters in

length for AISG 1.x devices and 1-32 characters in length for AISG 2.0 devices, and

may contain any combination of numbers and letters.

The

Installation Date field must be 1 to 6 characters in length with any combination of

letters and numbers.

The

Installer ID must be 1 to 5 characters in length with any combination of letters

and

numbers.

• The Sector value must be 1 to 4 characters in length for AISG 1.x devices and 1-32 charac

ters in length for AISG 2.0 devices, and may contain any combination of numbers and letters.

4. Carefully review all data entered (Figure 23-5). If satisfied that all are correct, click on Set Device

Data. Alternately, the user may go back and edit/change any of the selections made or click on

Close to quit this process without making any changes to the TMA’s current configuration.

5. TMA Data fields (TMA Type, TMA Rx Band, TMA Tx Band, Max Gain, Min Gain and Gain

Resolution) are displayed as read only.

Figure 23-5. TMA Device Configuration Screen.

Fields marked with an asterisk
must be configured.

Click to set device data.

These fields are read only.

1. Make appropriate text entries.

This manual is related to the following products: