CommScope ATC300-2000 - Manual (Page 98)

Section 9–Uploading Controller Firmware Using the IP Config Tool ATC300-1000/2000 Teletilt ® RET System
9-10 August 2014 Bulletin 639544 • Revision L
Figure 9-10. Uploaded Controller Firmware Files Shown.
Controller firmware files are
shown, which includes bundled
antenna definition files.
The Reboot button is used
to reboot the controller.
This is required when firm-
ware updates are installed
for the controller.
9.5 Uploading Other Antenna Supplier Definition Files
Other antenna supplier definition files can be uploaded into the ATC300-1000/2000 or ATC200-1000
controller manually using the process described above. These files will need to be obtained from the
antenna supplier. Refer to www.aisg.org.uk for information on the standards and the abbreviations for
each antenna supplier.
9.6 FTP Server Conflict
If another FTP server is registered and running on the local computer, a conflict will normally occur
with the FTP Server used by the IP Config Tool.
To check to see if another FTP server is running, first close the IP Config Tool and then open Internet
Explorer.
Go to ftp://localhost/. If this opens, there is another FTP server running.
To correct any conflicts that occur, the FTP server will need to be closed. To prevent reoccurrence
of the conflict, the FTP server will need to be unregistered. See example shown in Figure 9-11 when
FTP server conflict has occurred.
Click on Close.