CommScope ATC300-2000 - Manual (Page 92)

Section 9–Uploading Controller Firmware Using the IP Config Tool ATC300-1000/2000 Teletilt ® RET System
9-4 August 2014 Bulletin 639544 • Revision L
Figure 9-3. Controller’s Main Interface Screen.
7. Double-click on an Internet browser to verify that the computer is connected to the controller. If
you are using the default IP address for the controller (192.168.255.141), the Internet browser
(Netscape and Mozilla not supported) will automatically open to the controller’s main interface
screen (Figure 9-3). If you are using a different IP address (see Chapter 5), enter that alternate
IP address for the controller in the browser window’s URL.
Note: This screen can be closed or minimized after connection has been verified.