CommScope ATC300-2000 - Manual (Page 97)

ATC300-1000/2000 Teletilt ® RET System Section 9–Uploading Controller Firmware Using the IP Config Tool
Bulletin 639544 • Revision L August 2014 9-9
3. Enter the IP address for the controller that is to receive the file upload (Figure 9-8).
Note that ‘*.tar’ type files are only used with the ATC300-1000/2000 Controller, so the screen
shown in Figure 9-8 will only allow this option to be selected.
4. Click on OK (Figure 9-8).
The Internet browser will open to the controller’s operating interface and upload the file.
A script will display indicating that the file was successfully installed (Figure 9-9).
Figure 9-8. Specifying The Controller To Receive The File Upload.
1. Enter IP address
for controller that
is to receive file
upload.
2. Click on OK.
Figure 9-9. File Uploaded To Controller Successfully.
Click on Back to see the uploaded antenna definition
file(s) listed and to go to controller’s screen displaying
the reboot button (see Figure 9-10).