CommScope ATC300-2000 - Manual (Page 39)

Section 3–Changing IP Settings on the Local PC Using the IP Config Tool ATC300-1000/2000 Teletilt ® RET System
3-6 August 2014 Bulletin 639544 • Revision L
3.5 Backing Up New IP Settings for the Local Computer
1. The new IP address can be saved for future access to the controller from the same computer.
Click on the Backup/Restore tab, located at the top of the screen (Figure 3-6).
2. Click on the Backup button (Figure 3-6).
3. Type in a name of your choice for the new IP configuration backup file, and click on OK (Figure
3-6).
Figure 3-6. Saving New IP Backup File For Future Access To The Controller.
1. Click on Backup/Restore tab.
2. Click on the Backup button.
3. Type in a name for the new IP backup file.
(Ex: Cell site name where controller resides)
4. Click on OK.