CommScope ATC300-2000 - Manual (Page 171)

Section 21–Adjusting Fan-Single SmartBeam ® Antenna ATC300-1000/2000 Teletilt ® RET System
21-2 August 2014 Bulletin 639544 • Revision L
The Fan Axis Movement screen shown in Figure 21-2 displays the information that was previously
configured for the device. This information may be used as a reference to help determine the new
beamwidth setting. Note that only movement changes may be made from this screen. Any changes
needed to be made to the configuration for the device must be done from the Device Configuration
screen as discussed in Section 12.
3. Enter the new beamwidth for the device in the New Beamwidth field. Note that the allowed range
of values is displayed in the Min Nominal Beamwidth and Max Nominal Beamwidth fields in
the top part of the screen. Any value within this range may be entered. Values may be entered as
whole degrees only. (Figure 21-2).
Examples: A value of eighty may be entered as 80. A beamwidth of eighty and one-half degrees
is not valid.
4. Click on Set Beamwidth to apply the changes to the fan axis for this antenna. Alternately, to exit
the screen without sending any changes, click on Close.
Figure 21-2. Changing Beamwidth Setting For Single Antenna.
1. Review the beamwidth range to verify that the new beamwidth value will be valid
for the antenna model.
2. Enter the new beamwidth value.
A value may be entered as whole values only
(Ex: 80).
3. Click on Set Beamwidth.