CommScope ATC300-2000 - Manual (Page 144)

Bulletin 639544 • Revision L August 2014 15-1
Section 15
Device Configuration for Antennas with
Multiple Integrated Actuators
15.0 Section Overview
Before the controller can successfully send commands to a known device, the device must first be
configured to provide specific information about the antenna and its location on the site. Actuators that
have been factory installed on an antenna are pre-configured to include the antenna model number,
antenna type, and antenna serial number (remaining fields will need to be configured). After each
device has been configured, the site configuration can be saved for future reference.
15.1 Configuring a Device
1. From the controller’s main interface screen, click on the device that is to be configured to select
it; then click on Edit Selected (Figure 15-1).
Figure 15-1. Selecting A Device For Configuration.
2. Click on Edit Selected.
1. Select the device that is to be configured. (Configuration settings will be missing for a factory new
device. If a device has been removed from the database, the data stored on the device from its last
configuration session is displayed when found in a new search.)