CommScope ATC300-2000 - Manual (Page 174)

Bulletin 639544 • Revision L August 2014 22-1
Section 22
Adjusting the Electrical Downtilt, Pan, or Fan
on a Group of SmartBeam
® Antennas
22.0 Section Overview
In addition to changing the downtilt, az offset, and beamwidth of a single SmartBeam antenna, changes
may also be applied to a group of antennas. The SmartBeam antennas that can be included in a group
move must be in the same sector, have the same electrical tilt range (same minimum and maximum
tilt), and be the same axis (tilt, pan, or fan).
22.1 Adjusting the Downtilt Angle, Az offset, or Beamwidth on a
Group of SmartBeam Antennas
1. Select a SmartBeam axis device from the controller’s main interface screen that is to be included
in the sector move (Figure 22-1).
2. Click on Move Sector (Figure 22-1).
Figure 22-1. Selecting A Device That Is To Be Included In The Sector Move.
1. Click on a device that is to be included in the sector move.
2. Click on Move Sector.