CommScope ATC300-2000 - Manual (Page 45)

Section 4–Changing IP Settings on the Local Computer Manually ATC300-1000/2000 Teletilt ® RET System
4-2 August 2014 Bulletin 639544 • Revision L
4.1 Changing the IP Address on the Local Computer
1. If the local computer has not been connected to the controller, see Section 6 to make this con-
nection using the Ethernet cable (supplied).
Note that the local computer will lose its connection to any company LAN (network system) when
it is disconnected.
2. Go to Control Panel
→Network Connections→Local Area Connection.
3. Click on Properties on the Local Area Connection Status screen (Figure 4-2).
Figure 4-2. Properties For Local Area Connection.
Click on Properties.