CommScope ATC300-2000 - Manual (Page 160)

ATC300-1000/2000 Teletilt ® RET System Section 18–Device Configuration with SmartBeam ® Antennas
Bulletin 639544 • Revision L August 2014 18-3
No specific unit of length, such as feet or meters, is associated with this field.
However, you should enter a value that conforms to the units of length customarily
used by your company for antenna installations.
• The ID for the base station associated with this antenna must be 1 to 12 characters
in length for AISG 1.x devices and 1-32 characters in length for AISG 2.0 devices,
and may contain any combination of numbers and letters.
• The Installation Date field must be 1 to 6 characters in length with any combination of
letters and numbers.
• The Installer ID must be 1 to 5 characters in length with any combination of letters
and numbers.
• The Location field is a string with a numeric value from 1 to 32 that describes an
actuator’s position within a sector. Each device should have a unique sector-location
combination.
• Mechanical tilt has a valid range of -12.8 to 12.7 in AISG 1.1, and ±180.0 in AISG 2.0.
• Values specified for the Frequency Band, Technology, and Mechanical
Tilt are used for reference only and have no direct affect upon the actuator/
antenna that is being configured. For SmartBeam, it may be configured only from the Tilt
Configuration screen.
5. Carefully review all selections. If satisfied that all are correct, click on Set Device Data (Figure
18-2). Alternately, the user may go back and edit/change any of the selections made or click on
Close to quit this process without making any changes to the actuator’s current configuration.
Figure 18-3. Device Configurations Complete.
Click on Close.