CommScope ATC300-2000 - Manual (Page 190)

Appendix A
Disabling and Enabling the Windows ® XP SP2
Firewall
A.0 Appendix Overview
• A firewall may block the use of an FTP server, which is needed for transferring firmware (soft-
ware) files to the ATC300/200 controller.
• The procedures discussed in this appendix only applies for the Windows ® XP SP2 firewall. For
any third-party firewall, please consult the manual or on-disk reference document supplied by the
vendor.
Note: Other IP connections, like an air card, must also be disabled.
A.1 Opening the Security Center
1. Go to the Control Panel (Start, Settings, Control Panel).
2. Double-click on the Security Center icon or link.
3. Click on Windows Firewall (Figure A-1).
Bulletin 639544 • Revision L August 2014 A-1
Figure A-1. Selecting Windows Firewall From The Security Center.