CommScope ATC300-2000 - Manual (Page 91)

ATC300-1000/2000 Teletilt ® RET System Section 9–Uploading Controller Firmware Using the IP Config Tool
Bulletin 639544 • Revision L August 2014 9-3
Figure 9-2. Restoring Backup IP Configuration File To Regain Access To Controller.
2. Click on the backup file.
3. Click on Restore.
1. Click on Backup/Restore tab.
4. Click on the Backup/Restore tab (Figure 9-2).
5. Click on the backup IP configuration file that was set up for access to the controller (Figure 9-2).
See Section 3.5 for creating a backup IP configuration file.
6. Click on Restore (Figure 9-2).