CommScope ATC300-2000 - Manual (Page 167)

Section 20–Adjusting Pan-Single SmartBeam ® Antenna ATC300-1000/2000 Teletilt ® RET System
20-2 August 2014 Bulletin 639544 • Revision L
The Pan Axis Movement screen shown in Figure 20-2 displays the information that was previously
configured for the device. This information may be used as a reference to help determine the new az
offset setting. Note that only movement changes may be made from this screen. Any changes needed
to be made to the configuration for the device must be done from the Device Configuration screen
as discussed in Section 12.
3. Enter the new az offset for the device in the New Az Offset field. Note that the allowed range of
angle values is displayed in the Min Azimuth Offset and Max Azimuth Offset fields in the top
part of the screen. Any value within this range may be entered. Values may be entered as whole
degrees only. (Figure 20-2).
Examples: A value of five may be entered as 5. A value of five and one-half is not valid.
4. Click on Set Azimuth Offset to apply the changes to the pan axis for this antenna. Alternately, to
exit the screen without sending any changes, click on Close.
Figure 20-2. Changing Az Offset Setting For Single Antenna.
1. Review the Azimuth Offset range to verify that the new Az Offset will be valid for
the antenna model.
2. Enter the new Az Offset.
3. Click on Set Az
Offset.