CommScope ATC300-2000 - Manual (Page 38)

ATC300-1000/2000 Teletilt ® RET System Section 3–Changing IP Settings on the Local PC Using the IP Config Tool
Bulletin 639544 • Revision L August 2014 3-5
3. In the fields provided, enter a new IP address that matches the controller’s IP address with the
final digit one digit lower (Example: Controller Factory Set IP is 192.168.255.141; New Computer
IP is 192.168.255.140). See Figure 3-5.
Note that the controller’s factory set IP is shown in the text below the entry fields provided for the
new IP address and is the same for all ATC300-1000/2000 controllers.
4. Click on the Apply new IP configuration button (Figure 3-5).
5. When the IP configuration is complete, the new IP address will appear as the Current IP (Figure
3-5).
Figure 3-5. New IP Address For Local Computer Shown As Current IP.
5. New IP Settings
Shown
3. Enter a new IP address that is one
digit lower than the controller’s
default IP address.
4. Click Apply new IP configuration button.