CommScope ATC300-2000 - Manual (Page 58)

ATC300-1000/2000 Teletilt ® RET System Section 5–Obtaining IP Settings for Controller (When IP is Unknown)
Bulletin 639544 • Revision L August 2014 5-9
8. Enter in a name for the connection, and click on Next (Screen 5, Figure 5-15) .
9. Select Communications cable between two computer (COM1) from the drop down
menu if it is not the default that appears, and click on Next (Screen 6, Figure 5-15).
10. Select Anyone’s use, and click on Next (Screen 7, Figure 5-15) .
11. Place a check mark in the box next to Add a shortcut . . ., and click on Finish (Screen 8, Fig
ure 5-15).
2. Click .
2. Click .
2. Click .
2. Click .
Figure 5-15. Setting Up a Direct Serial Connection (Screens 5 through 8).
1. Enter a name for connection.
1. Select.
1. Select.
1. Select.
5 6
8 7