CommScope ATC300-2000 - Manual (Page 115)

ATC300-1000/2000 Teletilt ® RET System Section 11–Device Discovery and Addressing
Bulletin 639544 • Revision L August 2014 11-3
11.2 Manually Adding a Device to the Controller’s System
To begin adding a device manually to the controller’s system, click on Configure Bus from the
controller’s main interface screen (this button is located under the Find Devices button as shown
in Figure 11-1).
1. Select an available address from the drop down list (Figure 11-4). If an address has already been
assigned to a device, it can not be reassigned to another device unless the present device holding
that address is first removed from the system (see paragraph 11.4).
2. Enter the device vendor code. This is 2 upper case letters, such as “AN” for Andrew.
3. Type in the serial number for the device to be added (Figure 11-4).
4. Select the correct AISG Version of this device (Figure 11-4).
5. Click on Add Device (Figure 11-4).
6. A progress screen will pop-up to show the device being added to the controller’s system. After the
device has been successfully added, click on Close Window from the progress window.
7. Scroll down in the Manual Addressing screen and click on Close.
Figure 11-4. Manually Adding A Device Using Configure Bus Feature.
1. Locate an
available address.
3. Enter the device serial number.
2. Enter the device vendor code.
4. Select AISG
version.
5. Click on
Add Device.
AISG Control Tools
See Paragraph 11.5