CommScope ATC300-2000 - Manual (Page 17)

Section 1
System Description
1.0 Section Overview
This section discusses the use of components used in the ATC300-1000/2000 or ATC 200-1000
Teletilt
® system.
1.1 ATC200-1000 Antenna System Controller
The ATC200-1000 controller, shown in Figure 1-1, serves as an interface between a local PC/lap-
top or a company network and the remote electrical downtilt devices (actuators/TMAs). This unit
uses software designed for communication between the controller and its attached AISG devices.
To download the latest software, go to the Andrew Products tab on
www.commscope.com , click on
Andrew→Products→Antennas→Teletilt RET System→Downloads→RET Controller Software
and Firmware ATC200-1000 Bundle.
Communication Ports and Power Connections (Figure 1-1):
• 9–pin ‘D’ style RS–232 connector port used to connect to a local PC’s COM port
• Ethernet port used to connect to a local PC’s Ethernet port or a network/Internet
• Both dc and ac connections for the power supply module
• 8–pin connector port (RET) for the AISG (Antenna Interface Standards Group) control cable as-
sembly, which is used to manage up to 32 AISG devices, e.g. actuators or TMAs
Includes:
• 4 Power cords (Australia/Asia, Europe, UK, and North America)
• Ethernet crossover cable
• Phoenix 48 Volt power connector (Caution! Ensure wires are properly connected.
Reversing wires can cause permanent damage to the controller.)
• Site Configuration Sheet (Contact your Andrew Sales Representative for ordering this item in a
higher quantity. Also, available online at www.commscope.com)
Bulletin 639544 • Revision L August 2014 1-1
Figure 1-1. ATC200-1000 Antenna System Controller