CommScope ATC300-2000 - Manual (Page 75)

7-4 August 2014 Bulletin 639544 • Revision L
Section 7–Changing the Controller’s IP Settings for Access Over a Network ATC300-1000/2000 Teletilt ® RET
7.1.2 Configuring the Controller to Use DHCP
The new IP settings should be noted and retained before the settings are applied to the controller.
Figure 7-4 shows a controller Config window set to DHCP.
1. Click the Use DHCP box. Enter a new Hostname if desired, or copy the default serial number
Hostname to use later in the browser’s address line (See paragraph 7.2).
2. Click on Set IP Details. Answer OK when the Proceed dialog appears (Figure 7-5).
3. Click on Reboot (Figure 7-4). The connection between the local computer and the controller will
be lost upon reboot.
4. Restore the local computer’s IP address to its network compatible settings (see Sections 3 and 4).
If the Andrew IP Config Tool was used to configure the local computer’s IP settings, the original
IP settings will be restored to the computer when the application tool is closed (see Section 3 for
details).
5. Connect the controller to the company’s LAN at the base station using an Ethernet cable, not
supplied.
• Enter the controller’s hostname, copied above, into the URL address window, and click on
Go. See Figure 7-6.
1. Click Use DHCP.
Copy
Hostname.
2. Click Set IP Details.
3. Click to Reboot.
Figure 7-4. Configuring Controller’s DHCP For Access Over a Network.