CommScope ATC200-1000 - Manual

ATC200-1000
Teletilt ® Control System
Equipment Installation Overview
Do not install near power lines.
Power lines, telephone lines,
and guy wires look the same.
Assume any wire or line can
electrocute you. Do not install on a wet or
windy day or when
lightning or thunder is
in the area. Do not use
metal ladder. Wear shoes with rubber soles
and heels. Wear protective
clothing including a
long-sleeved shirt and rubber
gloves.
Installation Training Available at Andrew Institute
SAFETY NOTICE
The installation, maintenance, or removal of an antenna requires quali f ed, experienced personnel. Andrew
installation instructions are written for such installation personnel. Antenna systems should be inspected once a
year by qualif ed personnel to verify proper installation, maintenance, and condition of equipment.
Andrew disclaims any liability or responsibility for the results of improper or unsafe installation practices.
WARRANTY NOTICE
Proper installation procedures must be followed when installing and operating RET equipment. Failure to assure
installations are done properly by trained installation personnel and to follow procedures discussed in this bulletin
may cause warranty for such products to be void.
Andrew requires that all RET installations be pre-tested and con f gured prior to installation. Failure to conduct
pre-test and pre-installation procedures def ned by Andrew will void warranty.
Bulletin 639513 • Revision G • September 2008