CommScope ATC300-2000 - Manual (Page 44)

Section 4
Changing IP Settings on the Local Computer
Manually
4.0 Section Overview
• In order for a local computer to gain access to the ATC300-1000/2000 or ATC200-1000 controller,
IP settings will need to be configured on the computer.
• An Ethernet cable (supplied) is required for communication between the local computer and the
controller to occur as shown in Figure 4-1 (see Section 6).
• After connection to the controller is no longer needed, the original IP settings for the local computer
must be restored in order for it to regain communication with a company LAN or other Ethernet
connection.
• The screens shown are examples from a Windows ® XP PC that has been configured to display the
‘Classic’ interface. Screens may differ with other versions of Windows ® .
• See Appendix B for understanding IP addressing.
Bulletin 639544 • Revision L August 2014 4-1
Figure 4-1. Local PC Connected To Controller’s Ethernet Port Using The Ethernet Cable.
Microsoft, Encarta, MSN, and Windows are either registered trademarks or trademarks of Microsoft Corporation in the United States
and/or other countries.
LMT
Serial Port
Ethernet
Port
Ethernet Cable