CommScope ATC300-2000 - Manual (Page 196)

ATC300-1000/2000 Teletilt ® RET System Appendix B–IP Addressing
Bulletin 639544 • Revision L August 2014 B-5
Figure B-11. Local Area Connection Properties.
Figure B-12. Local Area Connection Status.
Most computers are setup to use DHCP with their Home/Work Networks. If this is the case, the 7.
Obtain an IP address automatically radio button will be selected. If you have a static IP
address, the Use the following IP address radio button will be used (Figure B-9).
Ensure that you record your current settings, so when you have completed your work with the
ATC200/300, you can reset your system for Home or Office networking (Figure B-9).
Select 8. Use the following IP address radio button (Figure B-10).
Type the IP Address 192.168.255.140 and Subnet Mask 255.255.255.0 (Figure B-10). 9.
Select 10. OK.
Select 11. OK (Figure B-11).
Select 12. Close (Figure B-12). You can now close any additional windows.
Figure B-10. Enter New IP Address And
Subnet Mask.
Figure B-9. Setting Needed To Restore The Computer
To Its Original IP Identity.
Record the
computer’s
existing
setting.
Type the new
IP address
and Subnet
mask for your
ATC200/300
controller.