CommScope ATC300-2000 - Manual (Page 60)

ATC300-1000/2000 Teletilt ® RET System Section 5–Obtaining IP Settings for Controller (When IP is Unknown)
Bulletin 639544 • Revision L August 2014 5-11
4. Change the maximum speed to 115200, clear all check boxes, and click on OK (Screen 3,
Figure 5-17).
5. Click on the Networking tab (Screen 4, Figure 5-17).
6. Select PPP Windows 95/98/NT4/2000 Internet from drop down menu (Screen 4, Figure 5-17).
7. Place a check mark in the box next to Internet Protocol (TCP/IP), and select (Screen 4, Figure
5-17).
8. Click on OK (Screen 4, Figure 5-17).
See paragraph 5.2. 4 to active the new serial connection.
4
4. Click.
1. Click.
2. Select.
3. Place check mark in box and select.
3
3. Click.
1. Select.
2. Clear all boxes.
Figure 5-17. Configuring Serial Connection (Screens 3 through 4).