CommScope ATC300-2000 - Manual (Page 162)

Bulletin 639544 • Revision L August 2014 19-1
Section 19
Adjusting the Electrical Downtilt on a Single
SmartBeam
® Antenna
19.0 Section Overview
• The electrical downtilt may be adjusted on a tilt axis of a SmartBeam antenna that is addressed,
configured, and whose current state does not prevent antenna movement.
• Movement may be prevented when a device is not responding to commands from the controller, is
in the middle of a move or configuration change, or is experiencing a mechanical malfunction.
19.1 Adjusting the Downtilt Angle on a Single Antenna
1. From the controller’s main interface screen, select the device ending in a “.t” (for “tilt”) to be moved
(Figure 19-1).
2. Click on Move Selected (Figure 19-1).
Figure 19-1. Selecting Device To Be Adjusted.
1. Click on the device
that is to be adjusted.
2. Click on Move Selected.