CommScope ATC300-2000 - Manual (Page 71)

Section 6–Accessing the Controller Using a Direct Ethernet Connection ATC300-1000/2000 Teletilt ® RET System
6-2 August 2014 Bulletin 639544 • Revision L
Figure 6-3. ATC300-1000/2000 Controller Main Interface Screen.
Note that the factory default configuration for the ATC300-1000/2000 controller is DHCP*, with
the hostname set to the controller serial number. However, when a DHCP server is not available
at bootup, the controller will use the IP address 192.168.255.141.
The factory default IP address for the ATC200-1000 is 192.168.255.141.
Figure 6-3 shows an example of the controller’s main screen. See Section 5 for cases where the
controller’s IP address has been changed and is unknown.
See Part 3 of this User Guide for instructions on uploading the latest controller firmware and antenna
definition files needed for RET device setup and operations through the controller.
* Dynamic Host Configuration Protocol