CommScope ATC300-2000 - Manual (Page 54)

ATC300-1000/2000 Teletilt ® RET System Section 5–Obtaining IP Settings for Controller (When IP is Unknown)
Bulletin 639544 • Revision L August 2014 5-5
11. Type ifconfig as shown in Figure 5-7 and press Enter key.
Figure 5-7. Configure IP Address.
12. Observe the eth0 paragraph shown in Figure 5-8. The second line in this paragraph
contains the IP address for your Ethernet connection. Example inet addr:192.168.0.50
Mask:255.255.255.0.
Figure 5-8. Getting The IP Address For Ethernet Connection.