CommScope ATC300-2000 - Manual (Page 61)

Section 5–Obtaining IP Settings for Controller (When IP is Unknown) ATC300-1000/2000 Teletilt ® RET System
5-12 August 2014 Bulletin 639544 • Revision L
5.2.3 Establishing a Serial Connection for Windows ® 2000 Users
1. Go to Control Panel→Network and Dial-up Connections→Make a New
Connection→Network Connection Wizard (screens not shown).
2. Select Connect directly to another computer, and click on Next.
3. Select Guest, and click on Next (Screen 4, Figure 5-14).
4. Select either COM1 or COM2 from the drop down menu.
5. Select For all users, and click on Next.
6. Enter in a name for the connection, and click on Next.
7. Clear all the fields, and click on Properties.
8. Select either COM1 or COM2 from the drop down menu (use the same selection as chosen in
step 5).
9. Select the Show icon in taskbar when connected option, and click on Configure.
10. Change the maximum speed to 115200, clear all check boxes, and click on OK.
11. Click on the Options tab.
12. Select the Display progress while connecting and Prompt for name password, certificate,
etc options.
13. Click on the Networking tab.
14. Select PPP Windows 95/98/NT4/2000 Internet from drop down menu.
15. Place a check mark in the box next to Internet Protocol.
16. Click on OK.
See paragraph 5.2.4 to activate the new serial connection.