CommScope ATC300-2000 - Manual (Page 186)

ATC300-1000/2000 Teletilt ® RET System Section 23–Tower Mounted Amplifier
Bulletin 639544 • Revision L August 2014 23-7
23.5 Changing TMA Operating Mode
To change a TMA’s operating mode, select the TMA from the TMA device information list on the 1.
controller’s main screen, as shown in Figure 23-10. Then click on Change TMA Mode to enter
the TMA Device Operation screen (Figure 23-11). Notice that the ID for the device that was se-
lected from the main screen appears in the title bar of the Device Operation screen.
Figure 23-10. ATC300 Controller’s Main Interface Screen - TMA View.
Select the desired operating mode from the mode dropdown list, as shown in Figure 23-11.The 2.
operating mode options are Amplifier On or Amplifier Bypassed. Then click on Set Bypass
Mode.
Figure 23-11. Changing the operating mode on a TMA.
Select TMA
Click on Change TMA Mode
Select new operating mode.
Click Set Bypass Mode.