CommScope ATC300-2000 - Manual (Page 172)

ATC300-1000/2000 Teletilt ® RET System Section 21–Adjusting Fan-Single SmartBeam ® Antenna
Bulletin 639544 • Revision L August 2014 21-3
5. A progress indicator bar will appear in a pop-up window to continually provide an update for as
long as the move is in progress. You will be notified when movement is complete. Click on Close
Window from the pop-up window (Figure 21-3).
If for any reason the move failed to reach the new beamwidth specified, you will be notified of the
failure.
6. After the antenna has completed movement to its new beamwidth, the new value will be displayed
in the Current Beamwidth field and the New Beamwidth will be cleared in preparation for the
next move (Figure 21-3).
At this point, you may click on Close (Figure 21-3) to return to the controller’s main interface
screen (Figure 21-4). Alternately, this process may be repeated to further adjust the beamwidth
or to reapply changes where movement had previously failed, such as a temporary mechanical
jam.
Figure 21-3. Beamwidth Change Complete For Single Antenna Move.
Current bandwidth value show
the new bandwidth setting.
2. Click on Close.
1. Click on
Close Window.